PRESSING INSTRUCTIONS
1. Use a lint roller to remove any lint on the press area.
2. Pre-press the garment for 10 seconds to remove any moisture. Do NOT skip this step! It also helps to ensure you have a wrinkle-free surface and warms up your apparel for a better press result.
3. Place the design on the garment and press according to “Settings” below.
SETTINGS
DTF INSTRUCTIONS
1. Actual press settings may differ due to equipment used and environmental conditions such as geographical elevation, room temperature and humidity. You’ll know you are pressing correctly when you can see the pattern of the fibers of the garment can be seen under the transfer. Our new softer film performs best at these settings:
2. Press at high pressure (9).
3. 100% Cotton: start at 305-310F for 10 seconds and adjust as necessary
4. Polyester Blend: 290-300F for 10 seconds and adjust as necessary. A cool to cold peel is suggested for polyester - especially totes!
5. After pressing, wait 3-5 seconds, then peel the film from one corner in one consistent low and slow motion. Transfers can be peeled warm/hot or cool – they are on a hybrid film.
6. Cover with Teflon sheet or parchment paper and press the garment again for 5 to 10 seconds to secure the transfer.
SUBLIMATION INSTRUCTIONS
1. Press at light to medium pressure - too much pressure will risk ghosting of your image
2. Press at 380-400F for 60-75 seconds
3. Wait a few seconds, then carefully remove the transfer taking care not to move it while still on item you are pressing so as not to create any ghosting of your image.
NO SECOND PRESS is required for sublimation.
CARE INSTRUCTIONS - DTF
Wash garment with cold or warm water. Tumble dry at “delicate” setting.
Do not iron design directly. If necessary, iron at low setting on the inner side of the garment
